Cart Preview

Important Tips for the New Model Airplane Builder

Posted by Motion RC on |

  • Category: Beginner Help
  • Here are some important tips that will help prevent plane damage and assist with your build.

    1) - Read the instructions completely to familiarize yourself with the build.

    2) - Do not over-tighten screws. Extra large tools can exert excessive torque on screws, causing them to break themselves or surrounding support parts.

    3) - Check landing gear mounts to make sure they are glued in properly.  

    4) - Never use Loc-tite or any other brand of thread-locker in contact with or near plastic (it will cause it to become brittle and break).

    5) - Reinforce foam hinges with clear packing tape or 3M hinge tape as needed. This adds a second level of protection for your hinges to do their jobs appropriately.

    6) - Always test the adhesive you are using on an inconspicuous area first. See our Glues section for more tips on appropriate use of adhesives.

    7) - Remove pushrods from control horns (by unhooking the clevis) before plugging in your battery. This reduces the risk of a servo binding when it is first powered on, before you can adjust the servo's direction in your radio.

    8) - Follow the manual's guide carefully to set your aircraft's recommended CG (Center of Gravity), control throws (rate of travel), dual rates and expo (control sensitivity).

    9) - Make sure all control surfaces are moving in the proper direction based on your radio's stick inputs.  If you are not sure if the direction is correct, reference the owner's manual for illustrations.  If your manual does not have illustrations DO NOT FLY until you can have a seasoned RC pilot check them for you (or research proper control surface direction online).

    10) - Always ensure that your radio is turned ON BEFORE plugging in the battery, and after a flight, UNPLUG THE BATTERY BEFORE turning the radio off. It is important to remember this proper sequence.

    11) - Always set your flight timer conservatively for a first maiden flight. 3 minutes is a safe period to allow you to takeoff, trim the aircraft, and practice landing approaches. Land, record your battery voltage, and calculate a safe flight time, adding 30 seconds on each subsequent flight until you are landing consistently with the batteries at ~25% state of charge.

    12) - Do not leave a battery plugged into the aircraft for longer than 20 minutes.

    13) - Perform regular inspections and maintenance on your aircraft every ~10-15 flights, or especially after a hard landing or minor crash. Inspect the propeller for any cracks or damage. Inspect the retracts for smooth operation and ensure their grub screws are tight. Inspect the control hardware on your aircraft. If it uses fuel tubing to secure the clevis to the control horn, ensure the tubing is tight yet flexible, and isn't cracked or dried out.

    Older Post Newer Post

    Product added to your Wishlist Add to Wishlist Added in Wishlist Add to Wishlist
    Product added to your Wishlist Add to Wishlist Added in Wishlist Add to Wishlist